Info Center

If you rent equipment for events such as a local festival, open house, or any other event open to the public, this qualifies as a “public event,” and you must apply to the police for a permit to set up the equipment.If in doubt, it is a good idea to contact your local police (licensing department) to determine if your event is categorized as “public” or “private.” All our bouncy castles are inspected, approved, and insured. All the necessary information is in the Midt- og Vestjyllands Politi database,
so you just need to provide the name and ID number of the bouncy castle.

ID numbers:

Football Bouncy Castle
ID No.: TI-6829

Jungle Obstacle Course
ID No.: TI-6828

Frozen
ID No.: TI-6825

Pirate Slide
ID No.: TI-6827

Small Jungle Obstacle Course
ID No.: TI-6826

Jungle Safari
ID No.: TI-6983

Blaze and the Monster Machines
ID No.: TI-6984

Slush Ice

1. Pour juice and water into the container. (2 L juice and water to max, which is approx 10 L)
2. Turn on the main switch
3. Check all switches are set to 1
4. After about 3 hours the slush ice is ready. (Time may vary depending on how warm it is)

Popcorn

1. Turn on the “POWER & LIGHT” button, which must be on all the time to keep
the popcorn warm
2. Turn on “HEAT” and “TURN”
3. Add a tablespoon of oil and wait for it to melt
4. Add kernels and salt
5. Wait until there are 2-3 seconds between each pop
6. Turn off “HEAT” and “TURN”, and now empty the pot
7. Continue with the procedure
8. It is a good idea to start by making 3-4 batches and then refill as needed.

Soft Ice

1. Pour the soft ice mix into the top container. (Max 2 cartons)
2. Turn on the machine and press “Wash”
3. After about 2 minutes, stop the machine again.
4. Insert the plug into the hole at the bottom of the container.
5. Press “FREEZE”
6. You can now monitor the temperature in both the container and the freezing cylinder.
For the first batch, it is important to wait until it reaches 100% before taking out ice cream.
Important!
– The machine must be plugged into a dedicated outlet to have enough power
– There must be at least a 5-second break between each serving.

Candyfloss

1. Turn on both switches
2. Wait until it is warm
3. Add a spoonful of sugar
4. Twist the stick around to make candyfloss
5. When finished, turn off both switches
6. If you want to make more later, follow the same procedure

Draft Beer

1. DO NOT PLUG IT IN
2. Check that the front button is off (all the way to the left)
3. Check that the compressor at the back is on
4. Now plug it in
5. Attach the draft beer coupling to the keg (insert, turn, and press down)
6. Run all the clear liquid out of the machine and a whole beer (this must be done for both
taps if they are to be used)
7. Now turn on the front button (all the way to the right)
8. Wait 10 min
9. Now the speed at which the beer comes out of the tap should be adjusted
10. The small handle on the side of the tap should be fully up
11. Turn on the tap and turn the handle down until a fine clear stream of beer comes out
12. Now the system is ready