Draft Beer Guide

Draft Beer

1. DO NOT PLUG IT IN
2. Check that the button in front is off (all the way to the left)
3. Check that the compressor in the back is turned on
4. Now plug it in
5. Attach the draft beer connector to the keg (insert, twist, and push down)
6. Run all the clear liquid out of the machine and a whole beer (this should be done with both
taps if they are to be used)
7. Now turn on the button in front (all the way to the right)
8. Wait 10 min
9. Now the speed of the beer coming out of the tap should be adjusted
10. The small handle on the side of the tap should be fully up
11. Turn on the tap and turn the handle down until a fine clear stream of beer comes out
12. Then the system is ready